Re: Need Clutch info


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Dylan in Lewiston on Wednesday, April 09, 2008 at 15:18:42 :

In Reply to: Need Clutch info posted by Jay on Tuesday, April 08, 2008 at 23:41:51 :

I went to Vintage power wagons for my v8 conversion, to get a 1" 10-spline disc, I think they said it was out of a WM300. However I also vaguely remember him saying that I got the last one. I was not able to get the 1" 10 spline, combo from my local parts stores, nor was I able to find it online. The part #s that I tried to use they kept saying were obsolete. In short I was just about to have a disc custom made when I ran across the spline combo in the VPW catalog, I did however purchase a centerforce 11" pressure plate from my local NAPA. I bolted both to the flywheel outside of the vehicle, and could see no reason why they wouldn't work together. But if there if there was any way to use the 88' and up NP435 input shaft (which is to short for the hyd. bell according to my calculations) which is a 1" 23-spline combo it would greatly improve parts availability. Additionally this tranny would have the same bearing configuration as the older 435s(as opposed to the early 80's 435s which use a tapered roller bearing on the input shaft).

Dylan



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com