Re: Made in the USA


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Ron in Indiana on Wednesday, January 30, 2008 at 14:29:22 :

In Reply to: Re: Made in the USA posted by Randy in NJ on Wednesday, January 30, 2008 at 12:29:27 :

Randy, Eastwood has 3 styles. I had the #11279 before getting the 19017 bit. As Ken said in his post the type with the center pin is a pain to start. The center pin is spring loaded to push into the center of the bit. IF you can get it started it does a good job of drilling the keyword is IF. I need to try this new bit soon, soon as it warms up. Before you drill the first spot weld try this tip. Spray some paint in a contrasting color on the bedside and angles. This will locate your new angles exactly where the old ones were. A few measurements taken first help too. I also run a grinding disc over the spotwelds on the OUTSIDE of the bed to find them. Just lay it flat an remove just the paint on the surface to reveal the lower spotwelds. After you drill them all out you weld from he outside and clean up with a grinder. Go to Eastwood.com for the bit.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com