Posted by Jesse on Sunday, October 21, 2007 at 18:18:16 :
In Reply to: Ray's oil pan gaskets posted by Mark on Sunday, October 21, 2007 at 18:03:54 :
just remove the oil pan ,scrape the old gasket off as best you can and clean real good,apply silicon sealer to the side gaskets and apply to the bottom of the engine block were the old gasket was . A little film and press the gasket until dry.It should stay in place until dry. put the two end gaskets on the oil pan. They stick out about an inch on each side. no sealer. re-install. That's how I did mine and there is no leaks after a month. Hope this helps.
Follow Ups: