Re: cutting sheet metal


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Keith in Washington on Thursday, October 04, 2007 at 21:02:04 :

In Reply to: cutting sheet metal posted by Derek Bell on Thursday, October 04, 2007 at 18:22:14 :

The last thing you want to use is a torch. Sheet metal does not like the heat. It warps a lot if too much heat gets to it. I use cut off wheels on a die grinder for the fine work. I use a nibber to cut sheet metal out of the tuck. Sawalls work great. I do not like hack saws their name is appropriate.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com