Zerk fitting at shear pin?

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by chriscase on Wednesday, September 19, 2007 at 23:18:38 :

I had to heat up the yoke AND use a puller to get it apart. I figured I'd sand off the rust before re-assembly. But there is a threaded hole in the yoke. I don't think it would be for a set screw, how about a grease fitting, so the yoke doesn't get rusted to the shaft again?

My parts book doesn't show the PTO shaft.

Follow Ups:

I think its for a set screw - mannyc 10:13:20 09/20/2007

Winch INPUT shaft. - chriscase 11:46:51 09/20/2007
- it IS for a grease zerk - Clint Dixon 12:31:03 09/20/2007
  - Yup, turned out to be 1/4". - chriscase 16:34:55 09/20/2007

Re: Zerk fitting at shear pin? - David Sherman 01:16:12 09/20/2007

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com