Posted by J.B. on Wednesday, June 20, 2007 at 20:40:40 :
In Reply to: Need help wiring a 220v plug on spot welder posted by DG on Wednesday, June 20, 2007 at 20:24:23 :
That would be correct if all normal conventions were followed.
I personally would open the welder to confirm that the green went to ground.
You never know who was in there before you!
If that is the case and no 110 is needed
for control etc. ( eg a 4 wire setup. )
All should be as you stated.
J.B.
(Electrical Contractor, licensed electrician,5 yrs El at Cal Poly,
30+ years in the trade )
Follow Ups: