i have an truck / industrial timing cover

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by mannyc on Saturday, December 09, 2006 at 18:23:04 :

In Reply to: Re: Chris, posted by Gary Troxel on Saturday, December 09, 2006 at 17:03:59 :

its cast iron and the waterpump mounts higher. supposedly it is a very good mount and dave sexton did a conversion in his m37 using this timing cover. it is designed to support the front of the engine in a similar fashion to the flathead. i have the complete mounting setup too. anyone interested in using it for a poly conversion? i had it beadblasted and a new crank seal installed in prep for doing a poly conversion in my command car. i stuck with the flathead and now its surplus to my needs.

mannyc

i also have the centered one point mount for the front of a poly engine too. it mounts the engine to the truck frame in the front center.

Follow Ups:

Re: i have an truck / industrial timing cover - Kaegi 23:55:05 12/09/2006

Re: i have an truck / industrial timing cover - mannyc 17:23:01 12/10/2006
- Re: i have an truck / industrial timing cover - Kaegi 21:52:56 12/10/2006
- How'd you do the horn? - Ron in San Mateo 19:54:57 12/10/2006
  - How I did mine - Paul (in NY) 22:50:43 12/10/2006
  - Re: How'd you do the horn? - mannyc 21:17:08 12/10/2006
    - Clever..Thanks a lot, ntxt - Ron in San Mateo 22:44:49 12/10/2006

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com