Re: PTO Parts sources


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by achiem37 on Monday, December 04, 2006 at 12:54PM :

In Reply to: PTO Parts sources posted by John S on Sunday, December 03, 2006 at 10:31AM :

I just overhauled my exact same PTO and just machined up a new shifter shaft out of 304 stainless steel. The machining job took about 1 hour to cut the shaft to size and machine in the grooves and shifter fork set screws dimple. Polishes up reeeeeel nice to see from below as well. The original shaft was scored at the ends from rust and wear and tear. The stainless version although being a little softer will outlast the truck. Terry



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com