Re: Can anyone machine me a pilot bushing?

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by David Sherman on Saturday, January 28, 2006 at 9:09PM :

In Reply to: Can anyone machine me a pilot bushing? posted by Jonas on Saturday, January 28, 2006 at 6:52PM :

I probably can, and drop it by on my way to Seattle next Thursday, especially if you give me some tolerances. I have a couple 3053s in the basement so I can check it on that end. It sounds a little odd to me that the bushing is .005 tight of 3/4". If it's a .750" shaft wouldn't you want it .005 over, not under? I'll check mine. A pilot bushing is usually an easy sliding fit.

Follow Ups:

Re: Can anyone machine me a pilot bushing? - Jonas 9:48PM 01/28/2006

Re: Can anyone machine me a pilot bushing? - David Sherman 0:46AM 01/29/2006
- HaHaHa!!! Caught me! - Jonas 1:13AM 01/29/2006
  - Use one part instead of two.... - Gordon Maney 8:43AM 01/29/2006
    - Re: Use one part instead of two.... - Tom Petroff 9:37AM 01/29/2006
      - I'll hold off on making it until you decide - David Sherman 4:15PM 01/29/2006
        
        An alternative - Gordon Maney 8:40PM 01/29/2006
        
        Re: An alternative - Jonas 10:18AM 01/30/2006
        
        The goal of repair machining - Gordon Maney 1:48PM 01/30/2006

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com