Re: suggestion ship hub/drum/wheel to builder

Posted by COTM Mike Stone (Idaho, USA) on Monday, August 15, 2005 at 12:00PM :

In Reply to: Budd Wheel Bolt pattern and counter sink info needed posted by Will (in MI) on Monday, August 15, 2005 at 11:45AM :

that way there will be no question as to
dimensions
you also need the backside setting
and a profile drawing of the hub/drum
the drums on a PW are very large & there is
no clearance to run a Drop Center 16inch
wheel with the original drum brakes

Follow Ups:

• Re: suggestion ship hub/drum/wheel to builder - Will (in MI) 12:10PM 08/15/2005
  • Re: where is your wheel builder located? - COTM Mike Stone (Idaho, USA) 6:42PM 08/15/2005
    • North West Arkansas - Will (in MI) 7:20PM 08/15/2005
  • Why 17"? - Jonas 6:38PM 08/15/2005
    • Re: Why 17"? - Will (in MI) 7:18PM 08/15/2005
      • my last comment on this subject - COTM Mike Stone (Idaho, USA) 9:01PM 08/15/2005
        • Thanks Mike. - Will (in MI) 9:17PM 08/15/2005
    • Re: Why 17"??? - COTM Mike Stone (Idaho, USA) 7:13PM 08/15/2005
  • Re: suggestion ship hub/drum/wheel to builder - COTM Mike Stone (Idaho, USA) 1:00PM 08/15/2005
    • Re: suggestion ship hub/drum/wheel to builder - Will (in MI) 7:16PM 08/15/2005
      • Re: that might be too much - COTM Mike Stone (Idaho, USA) 8:42PM 08/15/2005
    • Re:a 17 inch drop might not clear the drum - COTM Mike Stone (Idaho, USA) 2:47PM 08/15/2005

Post a Followup