Posted by David (Big D) on Monday, July 18, 2005 at 9:53PM :
In Reply to: Re: New Big Block Performance Part ! posted by Russ/Wyo on Monday, July 18, 2005 at 3:47PM :
Hi Russ =
I will email you the details. I can tell you George Asche can make you a dual or triple from a stock intake/exhaust setup as well.
He is in Venus PA - 814-354-2621 and tell him George English (big d) sent you.
This is a higher end deal. If an edmunds triple was 100% this flows 280% of that. It is a higher end alumimum cast item. You can bolt carter ball and balls right on it, but you can get adapters for other carbs.
George makes by far the best stainless linkage on the planet for his homemade units so I would say yes they will have linkage available. Truck slightly different than car, car with overdrive slightly different than non-overdrive.
In terms of setup, I understand it bolts right on to the block as a standard intake. our exhaust would work I expect, although I think you would want dual exhaust for sure.
Again George makes big block headers from stock intakes.
AoK is Asche and Kingsbury, so I would say give George a call. In the mean time I will
email you the details on cost and pictures etc.
David
Follow Ups: