Update

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by Will (in MI) on Sunday, April 10, 2005 at 4:15PM :

In Reply to: Fab'ed the M-37's Rear Motor Mounts Today posted by Will (in MI) on Saturday, April 09, 2005 at 10:11PM :

I used my torch and a file to slot the miss-drilled hole. I was off by a 1/4". Miss marked the location, my fault.

Here (http://m37.wawii.com/images/DSC03267.JPG) are the final brackets supporting the weight of the engine and holding it in my the location. I then notched the frame on the drivers side to clear the exhaust manifold, and the Intermediate Drive shaft looks good as well as the engine angle. The Intermediate Shaft has a 1/4" of slide in the slip joint, I will likely add a little more by shortening the male portion on the rear (M37) part of the shaft.

My 1953 M-37

Follow Ups:

Re: Weld the hole closed - Willy-N 11:14PM 04/11/2005

Re: Weld the hole closed - Will (in MI) 10:20PM 04/12/2005

Re: Update - Tim Holloway 10:06PM 04/10/2005

Re: Update - Will (in MI) 10:46PM 04/10/2005

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com