Posted by Jim in OK on October 21, 1999 at 22:39:58:
Could someone tell me about the 90 degree belt pto that was made for the Powerwagons?These units bolted on in place of the pintel hitch.This particular unit I ran across has the following letters& #....L&SC-10002...casting#640503...W.O. DESIGN...Pat.#143394.The pulley is 6-7" wide and about the same in diameter.The gearbox input requires a male shaft simular to the most common tractor pto shafts.Also,are the bolt holes in the rear crossmember in a square pattern or are two off-set?If this pto unit is correct,whats it worth? Thanks Jim in OK.