Had to Re/Do the Winch Skid Plate, PicT


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Willy-N on Wednesday, February 02, 2005 at 5:25PM :

After looking at the plate real good I relised the Cable would drag on the front of the plate if I had to pull myself over a bank or pull some one up a bank when I was above them. I cut the plate back for the maxium angle with out the cable draging on the threaded rod and welded in a 1 inch steel rod for a Lower Fairlead and beefed it up with 1 1/2" X 1/4 inch Angle Iron for cable guides. This stops the cable from going under the bummper and hanging up. Now the plate will not deflect on a pull. The skid plate is much stronger then before and should work a lot better. Mark H.



Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com