Re: WM300 driveshaft question

[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]

Posted by OTM Mike Stone in Idaho USA on Thursday, December 23, 2004 at 1:43PM :

In Reply to: WM300 driveshaft question posted by Kevin on Thursday, December 23, 2004 at 1:35AM :

The BEST engineers in the world designed
these trucks with access to all the data
required for design (which is not available to the rest of us) if they had seen fit to move the drive shaft to the transfer case is it not logical that it would have been done sometime in the 25 years or so of the T137 production run ???
now the configuration you suggest might have worked in 99.999 % of use but that is not good enought for equipment that was used all over the world under every possible condition

Follow Ups:

Lionel had .... - MoparNorm 3:16PM 12/23/2004

Re: Lionel had .... - Clint Dixon 4:25PM 12/23/2004
And used up surplus WC62 axles? or front castings work on rear? - chris case 3:26PM 12/23/2004

Engineers? - Clint Dixon 2:09PM 12/23/2004

Re: Engineers? - OTM Mike Stone in Idaho USA 2:22PM 12/23/2004
- postman - Clint Dixon 2:35PM 12/23/2004

Post a Followup

Name:
E-Mail:
Subject:
Message:

Optional Link
URL:
Title:
Optional Image Link
URL:

This board is powered by the Mr. Fong Device from Cyberarmy.com