Clutch Dilemma

Posted by Tim Holloway on Sunday, September 05, 2004 at 3:17PM :

OK, here is the scenario: I needed to replace my transmission in my PowerWagon. Naturally while I have it all apart I wanted to replace the clutch, although the clutch was working fine. Got all of the parts from VPW and tore into it this morning. When I wnrnt to bolt the pressure plate up I discovered that I had an 11 inch pressure plate and a 10 inch disc. Naturally VPW sent all 10 inch stuff since that is what is supposed to be there. The flywheel is only drilled for the 11 inch plate. Here are my options:
1: send the pressure plate back for an 11 inch plate
2: send both pressure plate AND disc back and get both 11 inch components
3: use the new disc and my old pressure plate
4: pull a flywheel off another truck and go with the 10" parts
5:throw a steak on the grill and forget I even own a Power Wagon (temporary solution)
Thanks, Tim

Follow Ups:

• Re: Clutch Dilemma - Will (in MI) 10:01PM 09/05/2004
• 11in pressure plate has more spring tension... - chris case 7:56PM 09/05/2004
• Re: Clutch Dilemma - Vaughn 4:33PM 09/05/2004
• Re: Clutch Dilemma - Ron in Indiana 3:56PM 09/05/2004
  • Re: Clutch Dilemma - Ken See 11:09PM 09/05/2004
    • Huh? - Ron in Indiana 11:35PM 09/05/2004
      • Re: Huh? - Ken See 10:59AM 09/06/2004
      • Re: Huh? - Tim Holloway 0:16AM 09/06/2004
  • I agree with Ron as well!! - Eric B. 4:09PM 09/05/2004
  • Re: Clutch Dilemma - Tim Holloway 4:06PM 09/05/2004
    • Re: Clutch Dilemma - Ron in Indiana 7:02PM 09/05/2004
      • Hi Ron - Mark P 11:36PM 09/05/2004
        • Re: Hi Ron - Ron in Indiana 7:16AM 09/06/2004
• Re: I'll vote for the steak - Gordon 3:48PM 09/05/2004
  • Re: I'll vote for the steak - Tim Holloway 3:54PM 09/05/2004
  • I agree with Gordon.... - Eric B. 3:52PM 09/05/2004
    • Re: I agree with Gordon.... - Tim Holloway 3:55PM 09/05/2004
      • Well, long term.... - Gordon 3:16AM 09/06/2004
        • Re: Well, long term.... - Tim Holloway 7:52AM 09/06/2004
          • If it comes down to scrap... - Gordon 9:30AM 09/06/2004
            • Re: were are you at??... - chester 1:24PM 09/06/2004

Post a Followup