Re: Vacuume & Hydro Line Routing


[ Follow Ups ] [ Post Followup ] [ Dodge Power Wagon Forum ] [ FAQ ]

Posted by Paul on August 15, 1999 at 23:06:55:

In Reply to: Vacuume & Hydro Line Routing posted by John M on August 15, 1999 at 16:35:23:

{{1.) Routing of vacuum line from carburetor to distributor. I have seen it run over the top of the head (the most direct route) and I have seen it run underneath the water pump (between the water pump and front engine mount) is either of these routes correct?

2.) Front brake lines seem to want to hard connect to the frame rails on either side and then go the distance between frame rail and wheel cylinder in hydraulic hose. This is a distance of over 1'-0" each side. That seems like a fairly long distance to run flexible hydraulic hose. Any suggestions?

3.) It seems that the hydraulic clutch line should run over the top of the bell housing to the clutch master cylinder. Is this correct?}}


On question number 1, I've got an all origianl '50 B-2-C and the vacuum line for the advance does run over the head to the carb.. On #2, my brake lines are set up the same way on the '50. A foot is a bit long but not unheard of. I'm afraid I haven't a clue on #3 as all my Dodges have the mechanical clutches.


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:

Optional Link URL:
Link Title:
Optional Image URL:


[ Follow Ups ] [ Post Followup ] [ Dodge Power Wagon Forum ] [ FAQ ]