1977 Dodge D600 Boom/Winch truck $3,900 [NM]


[Follow Ups] [Post Followup] [Dodge Power Wagon Forum]


Posted by Photo Classified on Sunday, November 23, 2003 at 6:11PM :

1977 Dodge D600 Boom/Winch truck

318 engine, 4-speed trans, and 30,000 pound Tulsa winch with 1” cable and self-storing gin poles.
Very stout bed with rolling tailboard, mounts for 3 “Jerry” cans and steps on both sides.
4 large locking tool boxes with parts storage, custom front bumper with pipe vise.
Gooseneck and bumper pull hitches with wiring and aux. trailer brake to both.
Wiring and antenna for CB radio.
2 gas tanks with individual gauges (cab tank needs plumbed – parts included)
Tires approx. 60-80%.
Good title, currently registered.

In the past 400 miles (or less) have put approx. $3,600 into the truck, not limited to:
Replaced engine
New carb, plug wires, battery, starter, water pump
New clutch/pressure plate
New brakes, bearings, seals in both front and rear end
New brake master cylinder and Hydro-Vac unit
PTO resealed
New custom upholstery on seat

Truck runs and drives fine. Windshield is cracked, but I will include a good one if you want to pull it.

Gas-powered air compressor is not included, but would sell for $150 with the truck.

Price is $3,900.

Please contact Dale, 505-533-6966 or canyonrose@yahoo.com

Located in Western New Mexico.






Follow Ups:



Post a Followup

Name:
E-Mail:
Subject:
Message:
Optional Link
URL:
Title:
Optional Image Link
URL:


This board is powered by the Mr. Fong Device from Cyberarmy.com